Problem
Make a paste extruder print reliably on a KUKA KR10 with a clay mix.
What I did
Mounted a WASP clay kit on the robot, wired the stepper motor, driver and Arduino controller, calibrated extrusion speed, and mapped water content, air pressure and robot speed over ten trials. Failures such as tubing clogs and controller overheating were diagnosed and documented.
Role
Graduate research assistant. I set up the extruder, wiring and control, calibrated its speed, wrote the KUKA robot programs and ran the print trials.
Credits
Clay recipe and process guidance from I. Datta and E. Baharlou.
Links
No public links yet.